PYREX® One Piece Continuous Liquid/Liquid Extractor System, Corning

Supplier: Corning
PYREX®
3920-M
89091-206CS 845.1 USD
89091-206
PYREX® One Piece Continuous Liquid/Liquid Extractor System, Corning
Extractors Liquid-Liquid Extractors
Made of PYREX® borosilicate glass. These continuous extractor systems are for use with solvents of heavier specific gravity than sample liquid being extracted.

  • Extraction can be performed outside the hood
  • Designed to meet EPA test method requirements outlined by SW-846, RCRA, and CLP

The sidearm is sealed to the extractor body just below the 45/50 [ST] outer joint. The sidearm is sealed higher on the body to reduce the chance of water spilling over while draining remaining solvent from the extractor body at the end of the extraction. Extraction can be performed outside the hood. However, as dictated by safe laboratory practices, it is recommended that some type of ventilation system be used above or near the units in case of a drop in condenser water temperature or loss of condenser cold water supply.

Delivery information: Supplied with Allihn condenser with 45/50 [ST] inner joint and 500 ml; PYREX® round bottom boiling flask with 24/40 [ST] outer joint.
Order Now

Learn more

About VWR

Avantor is a vertically integrated, global supplier of discovery-to-delivery solutions for...

Learn more About VWR